Polymer Processing Additive（PPA-5919H）
PPA-5919H is a high temperature resistant, free flowing white powder fluoropolymer based processing additive. At a very low level addition(450-1100ppm), it can improve PE processing and does not affect the original physical property of the plastics as well as sealing, adhesion and printing, can be used for mLLDPE, LLDPE, HDPE, LDPE, EVA and other polyolefin resin.
Product Form:
White to off-white powder
Product application:
Blow film, cast film, the hollow blow molding plastic products, pipe, sheets, masterbatch.
Notice: Not suitable for Nylon, BOPP films.
Physical Property:
|
Item |
UNIT |
SETTING |
|
Bulk Density |
g/cm3 |
0.75g/cm3 |
|
Particle size |
mesh |
25 |
|
Volatile |
（105℃ 1h)% |
0.10% |
Processing Guide :
The dispersion of PPA in resin determines the performance. The recommended process is to add PPA via 3%-5% Masterbatchthrough twin-screw extruder, and then add it into the extrusive resin according to the ultimate goal. The conditioning time is 10-60 minutes according to the equipment, base material and shear rate. No conditioning time when long-term use of this product.
Product Functions:
Improve film surface quality by eliminating melt fracture;
Reduce wears of a mold in the processing process, eliminate the die buildup;
Increase the ratio of LLDPE in LLDPE/LDPE blends for lower cost, higher quality;
Increase output and save energy.
Quality Guarantee Period & Storage:
2 years, below 30℃, store in cool dry and sun block condition.
Packaging:
Net weight 25Kgs per carton box
